Task Summary List - Nortel 1000 Installation And Commissioning Manual

242 2.0 Mb DTI implementation

Task summary list

The following is a summary of the tasks in this section:
1.
2.
3.
4.
5.
6.
LD 17 - Adding a 2.0 Mb DTI card
Prompt Response
REQ CHG
TYPE CEQU
...
xx
DTI2
LD 73 - Defining the 2.0 Mb DTI ABCD signaling bit tables
Prompt Response
REQ NEW
CHG
TYPE DTI2
FEAT ABCD
2-16
SICA
...
DFLT (1)-16
Incoming/Outgoing Calls:
IDLE(S) abcd
IDLE(R) abcd
FALT(S) abcd
N
FALT(R) abcd
N
Incoming Calls:
Copyright © 2003-2007, Nortel Networks
.
"LD 17 - Adding a 2.0 Mb DTI card" (page 242)
"LD 73 - Defining the 2.0 Mb DTI ABCD signaling bit tables" (page 242)
"LD 73 - Defining the 2.0 Mb DTI pad tables" (page 246)
"LD 73 - Defining the 2.0 Mb DTI timers" (page 249)
"LD 73 - Defining the 2.0 Mb DTI system timers" (page 252)
"LD 16 - Configuring the service routes" (page 253)
Description
Change.
Common equipment.
Enter a card slot number for 2.0 Mb DTI.
Description
Add or change Digital Trunk Interface data block.
2.0 Mb/s DTI data block.
ABCD bit signaling category.
Signaling category.
Default signaling category used for default values
JDMI defaults to 16 with <CR>
(Send) idle signal bits.
(Receive) idle signal bits.
(Send) bits. 2.0 Mb DTI out-of-service.
If FALT (send) signal not required.
(Receive) bits. 2.0 Mb DTI out-of-service.
If FALT (receive) signal not required.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
3 .