Nortel 1000 Installation And Commissioning Manual page 289

Dedicated mode
The DCHI uses the NTAK02 circuit card and does not support ISDN PRI
signaling. The DCHI is reserved for ISL use only. The D-channel can
communicate with the far-end by means of a dedicated leased line modem
or dialup modem.
Note that the following implementation relates to analogue TIE trunks being
used as B-channels. In the case where DTI/PRI trunks are also used, then
LD 17 digital loop (2.0 Mb PRI) and LD73 (2.0 Mb PRI/SYTI) must also be
configured with the appropriate clocking and threshold settings.
For ISL dedicated mode using a dialup modem, a 500 set, TIE trunk
route and member must be programmed (used for D-channel).
"Configuring basic ISL capability" (page 289)
steps.
Table 106
Configuring basic ISL capability
LD
Step
1 17
2 15
3 16
4 14
LD 17 - Configure the D-channel for ISL
Prompt
REQ
TYPE
ADAN
CTYP
CDNO
PORT
Copyright © 2003-2007, Nortel Networks
.
Action
Configure the D-channel for ISL use.
Enable ISDN option.
Enable the ISL option on a per route basis, assign a D-channel
for each route.
Assign a channel identification to each trunk with the ISL
option.
Response
CHG
CFN
NEW DCH 0-79
DCHI
0-15
1-9 11-19 21-29,
31-39 41-49
1-50
1
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
ISL software implementation 289
summarizes the required
Description
Change existing data
Configuration data block.
Add primary D-channel.
D-channel card type.
Serial Data Interface (SDI) Card number.
Number the SDI cards logically with the
system.
MSDL application small system Card
number
DCHI small system Card number
Must be set to 1.
Table 106