Nortel 1000 Installation And Commissioning Manual page 83

Figure 37
NT6D11 DCH with ISL low-speed programming jumper settings
Port addressing modes
Port 0 Mode selection
Port 0 is used to select whether the asynchronous ESDI port is be disabled
or not. Refer to
Table 24
Port 0 mode selection
Port Mode
Not used
Asynchronous ESDI
Port disabled
Port 1 mode selection
Port 1 is used to select the standard or expanded D-channel addressing
mode on the NT6D11AB/AE/AF. Refer to
(page
Copyright © 2003-2007, Nortel Networks
.
Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI 83
Table 24 "Port 0 mode selection" (page
Note: The asynchronous ESDI port must be set to "disabled".
SW1.1
0
1
1
84).
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
83).
Switch Setting
SW1.2
-
0
1
Table 25 "Port 1 mode selection"