Nortel 1000 Installation And Commissioning Manual page 224

224 1.5 Mb DTI implementation
4
LD 17 - Adding a DTI card
Prompt Response
REQ CHG
TYPE CFN
...
PARM YES
...
PCML (MU) A
...
CEQU YES
DLOP ll dd ff
MODE TRK
TMDI (YES) NO
YALM DG2 (FDL)
0-15
TRSH
0 1 2
T1TE
LD 16 - Configuring a DTI trunk route
Prompt Response
REQ NEW
CHG
TYPE RDB
TKTP
Copyright © 2003-2007, Nortel Networks
.
Assign clock's reference source. See
reference source" (page
Description
Change existing data.
Configuration data block.
System PCM law.
Default is MU law.
Changes to common equipment.
Digital Trunk Interface Loop or Loops
Select Digital Trunk Interface mode.
Whether the card is a TMDI card.
Yellow alarm method — prompted only if the frame format
is ESF — Must match the far end.
Use FDL with ESF and use DG2 with non-ESF. If not
prompted then DG2 is set automatically.
The maintenance and threshold table to be used for this
DTI card, as configured in LD 73.
T1 Transmit Equalization (0=0-200 ft., 1=200-400 ft,
2=400-700 ft). Only for TMDI = YES.
Description
Add new data.
Change existing data.
Route data block.
Create a trunk route.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
"LD 73 - Assigning a clock
225).
—End—