Nortel 1000 Installation And Commissioning Manual page 263

Set the switches on the circuit card according to the requirements of your
specific installation:
Switch SW1 - DCHI configuration
This switch enables and disables the onboard DCHI and sets the operating
mode of the DCHI.
For the U.K., use DPNSS1 mode. For all other countries, use Q.931 mode.
Table 92
Switch SW1
Switch
SW 1-1
SW 1-2
Switch SW2 - Carrier impedance configuration
This switch sets the carrier impedance to either 120
cable is usually associated with 120
with the 75
Table 93
Switch SW2
Cable Type
75
120
Switch SW3 - Clock controller configuration
This switch enables and hardware disables the onboard Clock Controller.
SW 3-2 should be disabled if the onboard clock controller is not in use.
Table 94
Switch SW3
Switch
SW 3-1
SW 3-2
Switch SW4 - Carrier shield grounding
This switch allows for the selective grounding of the Tx/Rx pairs of the
carrier cable. Closing the switch (down position) applies Frame Ground
(FGND) to the coaxial carrier cable shield, creating a 75
configuration. This applies only to the NTBK05CA cable.
Copyright © 2003-2007, Nortel Networks
.
Down (On)
enable DCHI
DPNSS1/DASS2
1 / setting.
2
1 /
2
/
1
2
Down (On)
—
Disabled
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Install the NTAK79 PRI card 263
/ . Coaxial cable is usually associated
1
2
SW 2-1
Up (Off)
Down (On)
Up (Off)
—
Enabled
Up (Off)
disable DCHI
Q.931
1 / or 75 1 / . Twisted pair
2 2
SW 2-2
Down (On)
Up (Off)
Note
Spare
1 / unbalanced
2