Nortel 1000 Installation And Commissioning Manual page 215

Prompt Response
ISDN YES
- PNI (0) 1-32700
- HNPA NPA
- HNXX NXX
- - HLOC XXX
- - LSC 1-9999
LD 16 - Configuring an ISDN service route
Prompt Response
REQ NEW
CHG
TYPE RDB
xxx
TKTP
DTRK YES
- DGTP PRI
ISDN YES
- MODE PRA
Copyright © 2003-2007, Nortel Networks
.
Description
Special Number.
Location Code
Customer is equipped with ISDN.
Private Network Identifier. Each customer data block must
have a unique PNI when multi-customer option is equipped.
PNI = 1 is typical for CUST = 0. It must be matched by
the PNI in the far-end RDB.
Note: Using the default value of PNI = 0 prevents operation
of features like NRAG, NACD and NMS.
Telephone area code for this system. Sent as part of setup
message as calling line identification.
Telephone local exchange code for this system. Sent as
part of setup message as calling line identification.
Home location code (NARS), prompted when PRA = YES.
One to four digit Local Steering Code, if required in the
Coordinated Dialing Plan (CDP). LSCs are required only if
the CDP DNs are longer than the local PDNs.
The CLID sent for a CDP call is composed of the LSC
defined in LD 15 plus the PDN of the calling set. Various
ISDN network features depend on the CLID as the "return
address" for sending feature control messages.
Multiple LSCs can be defined in LD 87 for CDP, but only
one LSC can be defined here for CLID.
Description
Add new data.
Change existing data.
Route data block.
Trunk type.
Digital trunk route.
1.5 Mb PRI. Prompted only if PRA = YES in LD15.
ISDN option.
Route used for PRA only.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Install PRI hardware 215