Nt5D97Ad Dip Switch Settings - Nortel 1000 Installation And Commissioning Manual

134 NT5D97 Dual-port DTI2/PRI2 installation and removal

NT5D97AD DIP switch settings

The NT5D97 DDP2 card is equipped with 6x2 sets of DIP switches for
trunk parameters settings for port 0 and port 1 respectively. Additionally,
the DDP2 card is equipped with one set of four DIP switches for the Ring
Ground setting. The NT5D97AA/AB has one set of eight DIP switches and
NT5D97AD has two sets of ten DIP switches for the D-channel Handler
parameters setting.
The DIP switches are used for the setting of default values of certain
parameters. Firmware reads the general purpose switches, which sets the
default values accordingly
Table 45
DIP switch settings for NT5D97AD
ENB/DSB mounted on the face
plate
Ring Ground
DPNSS
MSDL
TX Mode
LBO Setting
Receiver Interface
General Purpose
Refer to DIP switch locations in
NT5D97AD" (page
Copyright © 2003-2007, Nortel Networks
.
Card
S1
135).
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Trunks
Port 0 Port 1
0 and 1
S16
S8 S9
S9
Figure 56 "Dip switches locations for
Trunk 0 Trunk 1
S2 S10
S3 S13
S4 S14
S5 S15
S6 S11
S12 S7