Procedure 36 Implementing Dti - Nortel 1000 Installation And Commissioning Manual

2
3
4
Use this procedure to implement the DTI software interface between
systems or between a system and a central office.
Procedure 36
Implementing DTI
Step
1
2
3
Copyright © 2003-2007, Nortel Networks
.
ENLL C
where
C is the DTI/PRI card number (DLOP). The card number
associated with a DTI/PRI card is based on the slot in which the
card is installed.
Under normal conditions, this step enables the clock controller and
D-channel interface. If enable fails, go to step 2.
Optional: Enter the following command in LD 60 to enable clock
tracking on the primary digital card:
ENL CC 0
Enter the following command in LD 96 to software enable the
NTAK93 (DCHI) daughterboard:
ENL DCHI N
where
N is the DCHI I/O address.
Within about 30 seconds, the D-channel layer 3 should be
established. To confirm, enter the following command in LD 60 to
request the current status of the D-channel:
STAT DCH (N)
The system response is:
DCH N EST OPER
This means that the D-channel is established and operational.
Action
Add a DTI card. See
Configure a DTI trunk route. See
route" (page 224).
Configure the trunks. See
225).
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Software enable the DTI/PRI cards 223
—End—
"LD 17 - Adding a DTI card" (page
"LD 16 - Configuring a DTI trunk
"LD 14 - Configuring the trunks" (page
224).