Software Enable The Dti/Pri Cards; Procedure 34 Enabling The Ntrb21 Tmdi Card; Procedure 35 Enabling The Ntak09 Card - Nortel 1000 Installation And Commissioning Manual

222 1.5 Mb DTI implementation

Software enable the DTI/PRI cards

Procedure 34
Enabling the NTRB21 TMDI card
Step
1
2
3
The DCHI and DTI cards must be implemented prior to software enabling
the NTAK09. Refer to the section
(page 212)
Procedure 35
Enabling the NTAK09 card
Step
1
Copyright © 2003-2007, Nortel Networks
.
Action
Enter the following command in LD 96 to enable the NTRB21 TMDI
card:
ENL TMDI x ALL
where
x is the NTRB21 TMDI card number (DLOP). The card number
associated with a NTRB21 TMDI card is based on the slot in
which the card is installed.
If in DTI mode, enter the following command in LD 96 to software
enable the D-channel:
ENL DCH y
where
y is the DCH port number that was assigned in LD 17.
Within about 30 seconds, the D-channel layer 3 should be
established. To confirm, enter the following command in LD 60 to
request the current status of the D-channel:
STAT DCH (N)
The system response is:
DCH N EST OPER
This means that the D-channel is established and operational.
for further information.
Action
Enter the following command in LD 60 to software enable all NTAK09
DTI/PRI cards:
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
—End—
Procedure 33 "Implementing basic PRI"