Nortel 1000 Installation And Commissioning Manual page 253

Prompt Response
xx
PREF CC1
xx
SREF CC1
xx
CC2
xx
PREF CC2
xx
SREF CC2
xx
CC3
xx
PREF CC3
xx
SREF CC3
xx
CC4
xx
PREF CC4
CCGD 0-(15)-1440
CCAR 0-(15)
LD 16 - Configuring the service routes
Prompt Response
REQ NEW
CHG
TYPE RDB
xx
CUST
Copyright © 2003-2007, Nortel Networks
.
Description
Primary Reference DTI/PRI loop for Clock controller one.
Primary Reference DTI/PRI loop for Clock controller one.
Card number for Clock Controller 2.
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
Card number for Clock Controller 3.
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
Card number for Clock Controller 4.
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
Clock controller free run guard time in minutes.
Clock controller audit rate. The time, in minutes, between normal
CC audits. Only programmable on units equipped with 2-Mb DTI.
Note 1: The clock controller prompts only appear for clocks
which are valid for the machine type being configured. The
prompts only appear if the system is in a valid state for the
definition of the 2.0 Mb DTI clock controller data that is, the DTI
clock references must be unused or in a free-run mode.
Note 2: Before programming clock controller references, the
QPC775 clock controller card(s) must be plugged in, and the
switches on the system's QPC441 3 Port Extender must be
appropriately set. Otherwise, the PREF and SREF prompts are
not given.
Description
Add or Change Route data block.
Route data block.
Customer number, as defined in LD 15
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
DTI software implementation 253