Nortel 1000 Installation And Commissioning Manual page 255

Prompt Response
NEDC
ETH
ORG
FEDC
ETH
FEC
JNT
(ORG)
DLTN YES (NO)
TIMER (30)-240
LD 14 - Defining the associated list of service trunks
Prompt Response
REQ NEW
CHG
TYPE TIE
COT
DID
CHID 1-382
TN l ch
s c
TOTN
PDCA (1) - 16
Copyright © 2003-2007, Nortel Networks
.
Description
Near-end disconnect control.
Either end control.
Originating end control. Default for TIE, ATVN, DID, and CCSA
trunk types.
Far-end disconnect control.
Either end.
Far-end.
Joint.
Originating end.
Dial tone on originating calls.
Network Ring Again duration timer time is in minutes.
Note: Package 148, Advanced ISDN Features, is required.
Description
Add or Change Trunk data block.
TIE trunk route.
Central Office trunk data block.
Direct Inward Dial trunk data block.
Channel ID for this trunk.
Loop and channel for digital trunks
New card slot and channel, where:
• s = 1-9 DTI2 card slot number (Option 11C main cabinet)
s = 11-19 DTI2 card slot number (IP expansion cabinet 1)
s = 21-29 DTI2 card slot number (IP expansion cabinet 2)
s = 31-39 DTI2 card slot number (IP expansion cabinet 3)
s = 41-49 DTI2 card slot number (IP expansion cabinet 4)
• c = 1-30, 2.0 Mb DTI channel
Pad Category Number. This prompt is given if the card is a 2.0
Mb DTI card, or if the card is a 2.0 Mb DTI card and the 1.5/2.0
Mb Gateway feature is equipped. For 2 to 16, the pad category
used must already be defined in LD 73.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
DTI software implementation 255