Nortel 1000 Installation And Commissioning Manual page 243

Prompt Response
SEZ(R) abcd
SEZD(R) abcd
N
SEZV(R) abcd
N
P CALL(R) abcd
TIME ON OFF
SEZA(S) abcd
N
P WNKS(S) abcd
N
TIME 10-(220)-630
P DIGT(R) abcd
N
NRCV(S) abcd
N
P EOSF(S) abcd
N
TIME (100)-150
P EOSB(S) abcd
N
TIME (100)-150
P OPCA(R) abcd
N
TIME 64-(128)-192
REPT (1)-5
CONN(S) abcd
CONN(R) abcd
P RRC(S) abcd
N
TIME 10-(100)-150
P BURS(S) abcd
Copyright © 2003-2007, Nortel Networks
.
Description
Seize signal (send or receive) for voice or data calls from or
to a non-SL-1.
Seize signal (send or receive) for data calls between SL-1s.
If SEZD(R) signal not required.
Seize signal (send or receive) for voice calls.
If SEZV(R) signals not required.
(Receive) signal sent during seize by an incoming CO trunk.
Length of pulse time on, and time off.
(default 2 seconds on, 8 seconds off)
Seize signal acknowledgment (send).
If SEZA(S) signal not required.
Wink start (corresponds to a pulsed seize acknowledgment).
Prompted when SEZA(S) not required.
If WNKS(S) signal not required.
Time for WNKS(S) signal in milliseconds.
(Receive) decadic pulses.
If DIGT(R) not required.
Number received signal (send).
If NRCV(S) signal not required.
End of selection free (send).
If EOSF(S) not required.
Time for EOSF(S) in milliseconds.
End of selection busy (send).
If EOSB(S) not required.
Time for EOSB(S) in milliseconds.
Operator calling time (receive) signal.
If OPCA(R) not required.
Time of OPCA(R) pulse in milliseconds.
Number of OPCA(R) pulses.
Connect send.
Connect receive.
Register recall (send) signal. Activated by Malicious Call Trace.
If RRC(S) not required.
Time of RRC(S) signal in milliseconds.
Bring up receiver (send). Uses switchhook flash timer for timer.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
DTI software implementation 243