Nortel 1000 Installation And Commissioning Manual page 276

276 2.0 Mb PRI implementation
Prompt Response
PNI 1-32700
HNPA NPA
HNXX NXX
HLOC XXX
1-9999
LSC
LD 16 - Defining a PRI service route
Prompt Response
REQ NEW CHG
TYPE RDB
xxx
TKTP
DTRK YES
DGPT PRI2
ISDN YES
MODE PRI
1-32700
PNI
xx
IFC
CHTY BCH
aaa
CTYP
<CR>
INAC YES
Copyright © 2003-2007, Nortel Networks
.
Description
Customer private network identifier. This number is unique to
this customer in the private network. For example, it is used as
part of the setup message for feature operation such as Network
Ring Again and Network ACD. Note that if PNI is set to zero (0),
NRAG and NACD does not work.
Telephone area code for this system. Sent in the setup message
as calling line identification.
Telephone local exchange code for this system. Sent in the
setup message as calling line identification.
Home location code (NARS)
One to four digit Local Steering Code established in the
Coordinated Dialing Plan (CDP). The LSC prompt is required for
Calling Line ID and Network ACD.
Description
Add new data.
Change existing data.
Route data block.
Trunk type.
Digital trunk route.
2.0 Mb PRI. Prompted only if PRA = YES in LD15.
ISDN option.
Route used for PRI only.
Customer private network identifier. Is the same as the CDB
PNI at far-end.
Interface type.
Signaling type. Prompted if DTRK is YES. D-channel signaling
for B-channels.
Call Type. Enter the call type to associate with the outgoing
route for direct dialing using the trunk access code (instead of
NARS access code).
Insert Access Code. Permits the NARS AC1 or AC2 access
code to be reinserted automatically on an incoming ESN call.
This prompt only appears on a TIE route and is set to "YES" for
features such as Network ACD to function.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007