Procedure 32 Enabling The Ntak09 Dti/Pri Card - Nortel 1000 Installation And Commissioning Manual

Procedure 32
Enabling the NTAK09 DTI/PRI card
Step
The DCHI and PRI cards must be configured prior to software enabling the
NTAK09. Refer to the procedure
(page 212)
1
2
3
Use this procedure to configure the PRI cards, DCHI interface, DCH link and
ISDN trunk route and trunks (B-channels) that are required to implement
PRI between systems. No feature applications other than Basic Call Service
are included in the implementation.
Copyright © 2003-2007, Nortel Networks
.
Action
for further information.
Enter the following command in LD 60 to software enable all NTAK09
DTI/PRI cards:
ENLL C
where C is the DTI/PRI card number (DLOP). The card number
associated with a DTI/PRI card is based on the slot in which the
card is installed.
Under normal conditions, this step enables the clock controller and
D-channel interface. If enable fails, enter the following command in
LD 60 to software enable clock tracking on the primary digital card:
ENL CC 0
Enter the following command in LD 96 to software enable the
NTAK93 (DCHI) daughterboard:
ENL DCHI N
where N is the DCHI I/O address.
Within about 30 seconds, the D-channel layer 3 should be
established. To confirm, enter the following command in LD 60 to
request the current status of the D-channel:
STAT DCH (N)
The system response is:
DCH N EST OPER
This means that the D-channel is established and operational.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Install PRI hardware 211
—End—
Procedure 33 "Implementing basic PRI"
—End—