Nortel 1000 Installation And Commissioning Manual page 235

Prompt Response
AC2
NPA
NXX
INTL
SPN
LOC
LD 16 - Enabling ISL option on a per-route basis, assigning a D-channel for each route
Prompt Response
REQ NEW CHG
TYPE RDB
xx
CUST
ROUT 0-511
0-127
TKTP TIE
DTRK YES/NO
ISDN YES
MODE ISLD
DCHI XX
1-32700
PNI
IFC
SL1
CTYP <CR>
INAC YES
Copyright © 2003-2007, Nortel Networks
.
Description
Access Code 2. Enter call types (type of number) that use
access code 2. Multiple responses are permitted. This
prompt only appears on NARS equipped systems. If a call
type is not entered here, it is automatically defaulted to
access code 1.
E.164 National.
E.164 Subscriber.
International.
Special Number.
Location Code.
Description
Add new data. Change existing data.
Route data block.
Customer number as defined in LD 15.
Route number Range for Large System and CS 1000E
system.
Range for Meridian 1 Small System, Media Gateway 1000B
TIE Trunk route.
Enter YES if this is a Digital Trunk Interface (DTI or PRI).
ISDN option.
Route for ISL application.
DCHI port number in CFN which carries the D-channel for
this TIE Trunk route.
Customer private network identifier. Must be the same as
the CDB PNI at the far-end.
Interface type.
Interface type
Call Type. Enter the call type to be associated with the
outgoing route for direct dialing using the trunk access code
(instead of NARS access code). See the Software Input
Output Reference — System Messages (NN43001-712)
for a list of valid responses.
Insert Access Code. Permits the NARS AC1 or AC2
access code to be reinserted automatically on an incoming
ESN call.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Basic ISL implementation 235