Nortel 1000 Installation And Commissioning Manual page 252

252 2.0 Mb DTI implementation
Prompt Response
GP2 T2 mt dt ct ot
FRFW YES (NO)
LD 73 - Defining the 2.0 Mb DTI system timers
Prompt Response
REQ NEW
CHG
TYPE DTI2
FEAT SYTI
MAND 0-(15)-1440
NCSD 0-(15)-1440
1S-59S
OSGD 0-(15)-1440
OOSC 0-(5)-127
PERS 0-(100)-254
DBNC (10)-32
xx
CCO
<CR>
X
xx
PREF CCO
xx
SREF CCO
xx
CC1
Copyright © 2003-2007, Nortel Networks
.
Description
Group 2 error thresholds.
This is the maximum amount of time that can occur before
software checks the associated thresholds of 120 to 32640
msec and rounds it to the closest multiple of 128 msec. T2 error
count values are in the range 1-(20)-255. NC = Error count
values are in the range 1-255.
mt = Maintenance threshold time (MNT).
dt = No new data calls threshold time (NNDC).
ct = No new calls threshold time (NNC).
ot = Out of service threshold time (OOS).
Note: The following requirements must be met for this input: mt
= >dt = >ct = >ot.
This 2.0 Mb DTI card is (is not) equipped with special Firmware
for France.
Description
Add or Change Digital Trunk Interface data block.
2.0 Mb DTI.
Change the switch timers and counters for 2.0 Mb DTI.
There is only one such block per switch.
Maintenance guard time in minutes.
New call suppression guard time in minutes and seconds.
Out-of-service guard time in minutes.
Out-of-service occurrences since midnight (DTI disabled).
Persistence timer in milliseconds for far-end problems.
Debounce timer in milliseconds.
Card slot number for Clock Controller 0.
No change for defaults.
To remove clock controller data.
Card number of PRI/DTI/SILC containing the primary clock
reference for the main cabinet
Card number of PRI/DTI/SILC containing the primary clock
reference for the main cabinet
Card number for Clock Controller 1.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007