To Install A New Tape Drive (No Tape Drive Previously Installed) - Nortel 1002rp Maintenance And Diagnostics

Replacing media drives
Note: Some settings may already be properly configured. If it is not clear
from the drive manufacturer's documentation how to set jumpers,
contact your Nortel technical support representative.
1 Set the SCSI ID to 6.
2 Disable the Active Terminators (Term Enable).
Note: Termination is provided by an active SCSI terminator that you
connect to the end of the SCSI cable (see "Cabling example" on
page 153).
3 Enable Parity Checking.
4 Enable Termination power (TPWR).
5 Leave the remaining settings at the default values.
To install a new tape drive (no tape drive
previously installed)
.
1 Courtesy down CallPilot, and then power down the server.
2 Ensure that the tape drive settings are as described in ""To
configure the tape drive"".
3 Remove the chassis cover.
4 Remove the media drive carrier (see "Removing the media drive
carrier from the chassis" on page 145).
5 Slide the new tape drive into the media drive carrier, and secure it
with four undercut Phillips-head screws.
Note: You may need to first remove other media drives from the
carrier to access the tape drive slot.
154
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
Standard 1.11
CallPilot