Set Pwa Maxrequest; Set Pwa Portcontrol - Enterasys D2 D2G124-12P Cli Reference Manual

set pwa maxrequest

Defaults
If port‐string is not specified, quiet period will be set for all ports.
Mode
Switch command, read‐write.
Example
This example shows how to set the PWA quiet period to 30 seconds for ports
D2(su)->set pwa quietperiod 30 ge.1.5-7
set pwa maxrequest
Use this command to set the maximum number of log on attempts allowed before transitioning
the PWA port to a held state.
Syntax
set pwa maxrequests requests [port-string]
Parameters
maxrequests
port‐string
Defaults
If port‐string is not specified, maximum requests will be set for all ports.
Mode
Switch command, read‐write.
Example
This example shows how to set the PWA maximum requests to 3 for all ports:
D2(su)->set pwa maxrequests 3

set pwa portcontrol

This command enables or disables PWA authentication on select ports.
Syntax
set pwa portcontrol {enable | disable} [port-string]
Parameters
enable | disable
15-66 Security Configuration
Specifies the maximum number of log on attempts.
(Optional) Sets the maximum requests for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
Enables or disables PWA on specified ports.
ge .1.5‐7: