Show Eapol; Show Eapol Output Details - Enterasys D2 D2G124-12P Cli Reference Manual

show eapol

This example shows how to reset the 802.1X quiet period to 60 seconds on ports
D2(su)->clear dot1x auth-config quietperiod ge.1.1-3
show eapol
Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display EAPOL status for ports
D2(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 15‐47 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to "set eapol" on
page 15‐17.
Table 15-47 show eapol Output Details
Output Field
Port
15-16 Security Configuration
(Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
Authentication State
--------------------
Initialize
Initialize
Initialize
What It Displays...
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
ge
.1.1‐3:
Authentication Mode
--------------------
Auto
Auto
Auto
CLI" on page 4-1.
ge
.1.1‐3: