Show Radius Accounting - Enterasys D2 D2G124-12P Cli Reference Manual

Examples
This example shows how to clear all settings on all RADIUS servers:
D2(su)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
D2(su)->clear radius timeout

show radius accounting

Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
Syntax
show radius accounting [server] | [counter ip-address] | [retries] | [timeout]
Parameters
server
counter ip‐address
retries
timeout
Mode
Switch command, read‐only.
Defaults
If no parameters are specified, all RADIUS accounting configuration information will be
displayed.
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is not currently enabled and global default settings have not been changed.
One server has been configured.
For details on enabling and configuring RADIUS accounting, refer to "set radius accounting" on
page 15‐8:
D2(ro)->show radius accounting
RADIUS accounting status:
RADIUS Acct Server
------------------
1
(Optional) Displays one or all RADIUS accounting server configurations.
(Optional) Displays counters for a RADIUS accounting server.
(Optional) Displays the maximum number of attempts to contact the
RADIUS accounting server before timing out.
(Optional) Displays the maximum amount of time before timing out.
Disabled
IP Address Acct-Port Retries Timeout Status
---------- --------- ------- ------- ------
172.16.2.10 1856 3 20 Disabled
D-Series CLI Reference 15-7
show radius accounting