Table of Contents
Advertisement
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
Connect a terminal to the local console port as described in your D‐Series Installation Guide. The
startup screen, Figure
Interface (CLI) by
•
using a default user account, as described in "Using a Default User Account" on page 1‐6, or
•
using an administratively‐assigned user account as described in "Using an Administratively
Configured User Account" on page 1‐6.
Figure 1-1
Username:admin
Password:
Enterasys D-Series
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2006
Chassis Serial Number:
Chassis Firmware Revision:
D2(su)->
Connecting Using Telnet
Once the D‐Series device has a valid IP address, you can establish a Telnet session from any TCP/
IP based node on the network. For information about setting the switch's IP address, refer to "set
ip address" on page 2‐9.
To establish a Telnet session:
1.
Telnet to the switch's IP address.
2.
Enter login (user name) and password information in one of the following ways:
–
–
The notice of authorization and the prompt displays as shown in Figure
For information about configuring Telnet settings, refer to "Starting and Configuring Telnet" on
page 2‐37.
1‐1, will display on the terminal. You can now start the Command Line
D-Series Startup Screen
If the switch's default login and password settings have not been changed, follow the
steps listed in "Using a Default User Account" on page 1‐6, or
Enter an administratively‐configured user name and password.
041800249041
1.0.xx
Using the Command Line Interface
1‐1.
D-Series CLI Reference 1-5
Hide quick links:
Advertisement
Table of Contents
