Set Diffserv Policy Class; Set Diffserv Policy Mark - Enterasys D2 D2G124-12P Cli Reference Manual

Mode
Switch command, read‐write.
Usage
In order to delete a policy you must first remove the service port(s) assigned to the policy using
the set diffserv service remove command as described in "set diffserv service" on page 8‐16.
Example
This example shows how to delete the Diffserv "admin" policy:
D2(rw)->set diffserv policy delete admin

set diffserv policy class

Use this command to add or remove a Diffserv class to a specified policy. Once added, policies
will be active for the specified class.
Syntax
set diffserv policy class {add | remove} policyname classname
Parameters
add | remove
policyname
classname
Defaults
None.
Mode
Switch command, read‐write.
Usage
Class must be added to a policy using this command before policy parameters, such as
bandwidth, marking, and policing, can be configured.
Example
This example shows how to add the "system" class to the "admin" policy:
D2(rw)->set diffserv policy class add admin system

set diffserv policy mark

Use this command to mark all packets for the associated Diffserv traffic stream with a specific IP
DSCP or IP precedence value.
Syntax
set diffserv policy mark {ipdscp | ipprecedence policyname classname value}
Adds or removes the specified class.
Specifies the policy name to be associated with the class.
Specifies a class name to add or remove.
set diffserv policy class
D-Series CLI Reference 8-11