Show Port Broadcast; Set Port Broadcast - Enterasys D2 D2G124-12P Cli Reference Manual

show port broadcast

Use this command to display port broadcast suppression thresholds.
Syntax
show port broadcast [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, broadcast status of all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the broadcast suppression thresholds for ports 1 through 4:
D2(su)->show port broadcast ge.1.1-4
Port
----------------------------------------
ge.1.1
ge.1.2
ge.1.3
ge.1.4

set port broadcast

Use this command to set the broadcast suppression threshold, in packets per second, on one or
more ports. This sets a threshold on the broadcast traffic that is received and switched out to other
ports.
Syntax
set port broadcast port-string threshold-val
Parameters
port‐string
threshold‐val
(Optional) Select the ports for which to show broadcast suppression
thresholds. For a detailed description of possible port‐string values, refer
to "Port String Syntax Used in the CLI" on page 4‐1.
Total BC Threshold
Packets (pkts/s)
0 50
0 50
0 40
0 14881
Select the ports for which to configure broadcast suppression thresholds.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐1.
Sets the packets per second threshold on broadcast traffic. Maximum
value is
• 148810 for Fast Ethernet ports
• 1488100 for 1‐Gigabit ports.
• 14881000 for 10‐ Gigabit ports
show port broadcast
D-Series CLI Reference 4-29