Feature Operation Within Hunt Groups; Table 134 Hunt Group Feature Operation - Nortel BCM 3.7 Manual

588

Feature operation within Hunt groups

Feature operation within Hunt groups
The operation of some features varies if the Business Communications Manager telephone is part
of a Hunt group. The following table shows the affected features.

Table 134 Hunt group feature operation

Feature
Call Forward All Calls
Call Forward No Answer
Call Forward on Busy
Do not Disturb on Busy
Group Pickup
Transfer via Hold
Priority Call
Ring Again
Line Redirection
Page Zones
Voice Call
N0008589 3.3
Description
The system ignores Call Forward All Calls feature and the Hunt group call
rings at the telephone.
The system ignores Call Forward No Answer and the Hunt group call
continues to ring until the hunt time expires.
The system ignores Call Forward on Busy and the Hunt group call continues
to ring until the hunt time expires.
If this feature is active, the set will not receive notification of incoming Hunt
group calls.
If a set is part of a Hunt group and a call pickup group, then an incoming Hunt
group call can be picked up from any set that is in the call pickup group.
The system supports transfer for Hunt group sets. However, you cannot
Transfer via Hold. Once you answer a call on a Hunt group set, its appearance
disappears from all other sets in the Hunt group. This means that other calls
can come in on the same line.
You cannot make Priority calls to Hunt group DNs.
You cannot use Ring Again when calling a Hunt group DN.
The Allow redirect attribute should be set to N for lines assigned to Hunt
groups. For more information, see
You cannot include Hunt group DNs in a Page zone.
Hunt groups cannot accept voice calls. Answer buttons have no appearances
for voice calls, and the set does not ring.
"Defining device capabilities" on page 417.