654
Remote Scope
Remote Scope
A remote scope is a remote network (not LAN1 or LAN2) that uses the DHCP Server to get IP
addresses through a DHCP relay agent.
This section describes:
•
"Adding a Remote Scope" on page 654
•
"Modifying Remote Scope settings" on page 655
•
"Configuring Remote Scope Address ranges" on page 655
•
"Configuring Remote Scope excluded addresses" on page 657
•
"Configuring Remote Scope Reserved Addresses" on page 659
•
"Remote Scope Lease Information" on page 660
•
"Deleting a Remote Scope" on page 661
Adding a Remote Scope
To add a Remote Scope:
1
On the navigation tree, click the Services key and click the DHCP key.
2
Click the Remote Scope heading and click the Add button.
Or, right click the Remote Scope heading and click Add.
3
Configure the remote scope settings according to the following table.
Table 164 Remote Scope settings
Attribute
Description
Subnet name
Allows you to specify the name of the remote scope.
Subnet Comment
Allows you to specify a description of the remote scope.
IP Address
Allows you to specify the IP address of the remote scope.
Enter the IP address in the dotted format.
Subnet Mask
Allows you to specify the subnet mask for the remote scope.
Enter the subnet mask in the dotted format.
4
Click the Save button.
N0008589 3.3