Using Routing To Create Networking; Figure 180 Dialing Plan For T1 E And M Routing Network - Nortel BCM 3.7 Manual

512

Using routing to create networking

Using routing to create networking
By properly planning and programming routing tables and destination codes, an installer can
create a numbering plan where T1 E&M lines between Business Communications Manager
systems are available to other systems in the network
The following figure shows a network of three Business Communications Manager systems. Two
remote systems connect to a central system.

Figure 180 Dialing plan for T1 E and M routing network

Pool H
T1 E&M
Each system must be running Business Communications Manager software. Each system must be
equipped with target lines and Business Communications Manager with a DTM with at least one
T1 E&M line or the appropriate Norstar trunk module configuration ported in through a Fiber
Expansion module (FEM). Programming information for this network is shown in the following
table.
N0008589 3.3
New York
Network # 2221
Received # 2221
Internal # 2221
Pool M
Toronto
Network # 6221
Received # 6221
Internal # 6221
Pool B
T1 E&M
Santa Clara
Network # 4221
Received # 4221
Internal # 4221
Pool N