Setting Up The Voip Gateway Dialing Plan - Hunt Groups; Setting Up The Voip Gateway Dialing Plan - Ip Routing Table; Figure 29 Channels - Hunt Group Screen For Simple Norstar Network - Nortel VoIP Gateway Configuration Manual

120 Example configurations
Setting up the VoIP Gateway dialing plan – Hunt Groups
On the Channels - Hunt Group screen:
1 Make an entry for each channel used.
2 For each channel, enter the E.164 number for that location. This will be the same number.
3
Assign each channel to Hunt Group 1.
Figure 29 shows the Channels - Hunt Group settings for the Head Office VoIP Gateway.

Figure 29 Channels - Hunt Group screen for simple Norstar network

Setting up the VoIP Gateway dialing plan – IP Routing Table
On the Tel To IP Routing & IP Security screen:
1 Enter the digit parsing rule for the number.
2 Enter the IP address of that destination.
In the sample screen shown in
for private network calls and one for Toll bypass (PSTN) calls. Also note that the last entry is "*"
which means the rule applies to everything that does not match a higher rule. In this case, those
calls are not routed.
Figure 30 shows the Tel To IP Routing & IP Security settings for the Head Office VoIP Gateway.
P0606298 02
Figure 30, note that there are two entries for the Calgary office, one