600
Using the Hospitality Services Admin telephone
Using the Hospitality Services Admin telephone
The front desk personnel can control alarms and from a two-line display administration telephone.
The following procedures are available to the users on the Hospitality User Card.
The following sections describe these processes:
•
"Hospitality Services admin alarm feature" on page 600
•
"Setting the state of a room at a telephone" on page 601
•
"Setting room condition" on page 601
Hospitality Services admin alarm feature
Only a Hospitality Services (HS) admin telephone can use the Hospitality Services admin alarm
feature. The Hospitality Services admin alarm feature is room-oriented. It does not control the
alarms on common telephones.
The Hospitality Services admin feature can:
•
determine the current or last alarm time set for a room
•
overwrite previous Alarm time programming for a room in the system
— assign an Alarm time for any room
— change an Alarm time for any room
— cancel an Alarm pending for any room
To program the Alarm time for a room with the Hospitality Services admin alarm feature:
1
Press FEATURE 877 on a two-line display telephone.
2
If configured, the display shows
3
Enter the Desk admin password.
The display shows
4
Enter the room number and press OK.
5
Press VIEW.
The display shows
6
If the alarm time is correct, press the
7
Enter a four-digit alarm time.
•
If the 24-hour format is used (hour: 00 to 23 and minutes: 00 to 59), no confirmation is
required. The display shows
•
If the 12-hour format is used, the display shows the four-digit time plus
the AM or PM display button. The display shows
pm ON
8
Press the RELEASE button to exit programming.
N0008589 3.3
Password:
.
Al of rm#:
Alrm: 07:00am OFF:
Alarm hh:mm ON
.
.
.
display button to activate the alarm.
ON/OFF
.
Alarm hh:mm am ON
. Press
AM or PM?
or
Alarm hh:mm