Srx550 High Memory Services Gateway Mini-Physical Interface Modules - Juniper SRX550 Hardware Manual

48
Figure 10: Example of a Standard GPIM (Installs in One Standard Slot)
Figure 11: Example of a Double-High, Single-Wide XPIM
Figure 12: Example of a Double-High, Double-Wide XPIM
Because the services gateway GPIMs communicate with the backplane at various performance levels, you
must install them in the correct slots.
NOTE: Remove the GPIM adapter before you install double-high, double-wide XPIM.

SRX550 High Memory Services Gateway Mini-Physical Interface Modules

The SRX550 High Memory Services Gateway has two slots (slots 1 and 2) for installing Mini-Physical
Interface Modules (Mini-PIMs).
A Mini-PIM is a network interface card that is installed in the services gateway to provide physical
connections to a LAN or WAN. The Mini-PIMs supported on the services gateway are field-replaceable
units (FRUs); which you can remove or replace at your site. You can install Mini-PIMs into the two Mini-PIM
slots on the front panel of the services gateway chassis.
The SRX550 High Memory Services Gateway supports the following Mini-PIMs: