Telnet Login; Ftp; Figure 203 Advanced > Remote Mgmt > Ftp - ZyXEL Communications ZYWALL P1 User Manual

18.13 Telnet Login

Use the following steps to Telnet into your ZyWALL's command interpreter. See
on page 467
1 If your computer is connected to the ZyWALL over the Internet, skip to the next step.
Make sure your computer IP address and the ZyWALL IP address are on the same
subnet.
2 In Windows, click Start (usually in the bottom left corner) and Run. Then type
and the ZyWALL's IP address. For example, enter
default IP address).
3 Click OK. A login screen displays. Enter the password at the prompts.
The default password is 1234. The password is case-sensitive.

18.14 FTP

You can use FTP (File Transfer Protocol) to upload and download the ZyWALL's firmware
and configuration files, please see
computer must have an FTP client.
To change your ZyWALL's FTP settings, click ADVANCED > REMOTE MGMT > FTP.
The screen appears as shown. Use this screen to specify which interfaces allow FTP access
and from which IP address the access can come.
It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 203 ADVANCED > REMOTE MGMT > FTP
ZyWALL P1 User's Guide
for more about the commands.
Chapter 23 on page 365
Chapter 18 Remote Management
Appendix H
telnet 192.168.167.1
for details. To use this feature, your
telnet
(the
305