Figure 67 Network > Lan; Table 24 Network > Lan - ZyXEL Communications ZYWALL P1 User Manual

Figure 67 NETWORK > LAN
The following table describes the labels in this screen.
Table 24 NETWORK > LAN
LABEL
LAN TCP/IP
IP Address
IP Subnet Mask
RIP Direction
ZyWALL P1 User's Guide
DESCRIPTION
Type the IP address of your ZyWALL in dotted decimal notation. 192.168.167.1 is
the factory default. Alternatively, click the right mouse button to copy and/or paste
the IP address. See Appendix D on page 441
The subnet mask specifies the network number portion of an IP address. Your
ZyWALL automatically calculates the subnet mask based on the IP address that
you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyWALL. See
subnetting.
RIP (Routing Information Protocol, RFC1058 and RFC 1389) allows a router to
exchange routing information with other routers. The RIP Direction field controls
the sending and receiving of RIP packets. Select the RIP direction from Both/In
Only/Out Only/None. When set to Both or Out Only, the ZyWALL will broadcast
its routing table periodically. When set to Both or In Only, it will incorporate the
RIP information that it receives; when set to None, it will not send any RIP packets
and will ignore any RIP packets received. Both is the default.
Chapter 6 LAN Screens
for details about IP addresses.
Appendix D on page 441 for details about IP
111