Configuring Password; Figure 230 Maintenance > Password; Table 137 Maintenance > Password - ZyXEL Communications ZYWALL P1 User Manual

Table 136 MAINTENANCE > General Setup
LABEL
DNS Servers
Used by System
Apply
Reset

23.4 Configuring Password

Click MAINTENANCE > Password to open the following screen. Use this screen to change
the ZyWALL's management password.
Figure 230 MAINTENANCE > Password
The following table describes the labels in this screen.
Table 137 MAINTENANCE > Password
LABEL
Old Password
New Password
Retype to Confirm
Apply
Reset
ZyWALL P1 User's Guide
DESCRIPTION
The ZyWALL uses these system DNS servers to resolve domain names for features
like VPN and updating the time and date from a time server.
The following applies when the ZyWALL is in router mode.
Select From ISP if your ISP dynamically assigns DNS server information. The
address field displays the (read-only) DNS server IP address(es) that the ISP
assigns.
Select User-Defined if you have the IP address of a DNS server. The IP
address must be public or a private address on your local LAN. Enter the DNS
server's IP address in the field to the right.
Select None if you do not want to configure DNS servers. If you do not configure
a DNS server, you must know the IP addresses of devices in order to access
them.
In bridge mode, these addresses are all user-defined. Enter the DNS server IP
addresses.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Type the default password or the existing password you use to access the system
in this field. If you forget the password, you may have to use the hardware RESET
button. This restores the default password of 1234.
Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays a (*) for each character you type.
Type the new password again for confirmation.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 23 Maintenance
367