Telnet; Configuring Telnet; Figure 202 Advanced > Remote Mgmt > Telnet; Table 95 Advanced > Remote Mgmt > Telnet - ZyXEL Communications ZYWALL P1 User Manual

Chapter 18 Remote Management

18.11 Telnet

You can use Telnet to access the ZyWALL's command line interface. Specify which
interfaces allow Telnet access and from which IP address the access can come.

18.12 Configuring TELNET

Click ADVANCED > REMOTE MGMT > TELNET to open the following screen. Use this
screen to specify which interfaces allow Telnet access and from which IP address the access
can come.
It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 202 ADVANCED > REMOTE MGMT > Telnet
The following table describes the labels in this screen.
Table 95 ADVANCED > REMOTE MGMT > Telnet
LABEL
Server Port
Server Access
Secure Client IP
Address
Apply
Reset
304
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using
this service.
Clear all of the interface check boxes to disable Telnet access to the ZyWALL.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
ZyWALL P1 User's Guide