Table of Contents
Advertisement
Chapter 1 Command Line Interface
5 If your login is successful, the command line appears and the status bar at the bottom of
the Console updates to reflect your connection state.
1.2.3 Telnet
Use the following steps to Telnet into your NXC.
1 If your computer is connected to the NXC over the Internet, skip to the next step. Make
sure your computer IP address and the NXC IP address are on the same subnet.
2 In Windows, click Start (usually in the bottom left corner) and Run. Then type
and the NXC's IP address. For example, enter
management IP address).
3 Click OK. A login screen displays. Enter the user name and password at the prompts.
The default login username is admin and password is 1234. The username
and password are case-sensitive.
1.2.4 SSH (Secure SHell)
You can use an SSH client program to access the CLI. The following figure shows an example
using a text-based SSH client program. Refer to the documentation that comes with your SSH
program for information on using it.
The default login username is admin and password is 1234. The username
and password are case-sensitive.
20
telnet 192.168.1.1
NXC CLI Reference Guide
telnet
(the default
Advertisement
Table of Contents
