Configuring Ssh; Figure 197 Advanced > Remote Mgmt > Ssh; Table 94 Advanced > Remote Mgmt > Ssh - ZyXEL Communications ZYWALL P1 User Manual

18.8 Configuring SSH

Click ADVANCED > REMOTE MGMT > SSH to change your ZyWALL's Secure Shell
settings.
It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 197 ADVANCED > REMOTE MGMT > SSH
The following table describes the labels in this screen.
Table 94 ADVANCED > REMOTE MGMT > SSH
LABEL
Server Host Key
Server Port
Server Access
Secure Client IP
Address
Apply
Reset
ZyWALL P1 User's Guide
DESCRIPTION
Select the certificate whose corresponding private key is to be used to identify the
ZyWALL for SSH connections. You must have certificates already configured in the
My Certificates screen (Click My Certificates and see
details).
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using
this service.
Clear all of the interface check boxes to disable SSH access to the ZyWALL.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
Chapter 18 Remote Management
Chapter 14 on page 239 for
301