Configuration Backup Using Gui-Based Tftp Clients; Using Ftp Or Tftp To Restore Configuration; Table 148 General Commands For Gui-Based Tftp Clients - ZyXEL Communications ZYWALL P1 User Manual

Chapter 23 Maintenance
where " " specifies binary image transfer mode (use this mode when transferring binary files),
i
" " is the ZyWALL IP address, "
host
name of the configuration file on the ZyWALL) to the file destination on the computer and
renames it config.rom.

23.19.6 Configuration Backup Using GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 148 General Commands for GUI-based TFTP Clients

COMMAND DESCRIPTION
Host
Send/Fetch
Local File
Remote File This is the filename on the ZyWALL. The filename for the firmware is "ras" and for the
Binary
Abort
Refer to Section 23.16 on page 379
over WAN.

23.20 Using FTP or TFTP to Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE YOUR device. When the restore configuration process is complete,
the device will automatically restart.
386
get
Enter the IP address of the ZyWALL. 192.168.167.1 is the ZyWALL's default IP address
when shipped.
Use "Send" to upload the file to the ZyWALL and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
to read about configurations that disallow TFTP and FTP
" transfers the file source on the ZyWALL ( ,
rom-0
ZyWALL P1 User's Guide