Network Conflict Avoidance; Configuring Device Mode (Zero Configuration); Figure 237 Maintenance > Device Mode (Zero Configuration Mode); Table 143 Maintenance > Device Mode (Zero Configuration Mode) - ZyXEL Communications ZYWALL P1 User Manual

23.12.1 Network Conflict Avoidance

Since your ZyWALL is portable, you may have different WAN interface settings in different
locations. In order to avoid network conflicts, the ZyWALL automatically overwrites the
following settings if they conflict with the ZyWALL's WAN settings:
• LAN
• LAN DHCP and static DHCP
• IPSec Virtual Address Mapping
• IPSec Port Forwarding Rules

23.13 Configuring Device Mode (Zero Configuration)

Click MAINTENANCE > Device Mode to open the following screen. Use this screen to
have your ZyWALL function as a router, a bridge or a simplified router (zero configuration).
Figure 237 MAINTENANCE > Device Mode (Zero Configuration Mode)
The following table describes the labels in this screen.
Table 143 MAINTENANCE > Device Mode (Zero Configuration Mode)
LABEL
Device Mode
Device Mode Setup
Router
LAN Interface IP
Address
ZyWALL P1 User's Guide
DESCRIPTION
This displays whether the ZyWALL is functioning as a router, bridge or simplified
router (zero configuration).
Select this radio button and click Apply to set the ZyWALL to router mode.
Enter the IP address of your ZyWALL' s LAN port in dotted decimal notation.
192.168.167.1 is the factory default.
Chapter 23 Maintenance
377