Vpn Wizard Network Setting; Figure 28 Vpn Wizard: Gateway Setting; Table 16 Vpn Wizard: Gateway Setting - ZyXEL Communications ZYWALL P1 User Manual

Chapter 3 Wizard Setup

Figure 28 VPN Wizard: Gateway Setting

The following table describes the labels in this screen.

Table 16 VPN Wizard: Gateway Setting

LABEL
Gateway Policy
Property
Name
My ZyWALL
Remote
Gateway
Address
Back
Next

3.4 VPN Wizard Network Setting

Use this screen to name the VPN network policy (IPSec SA) and identify the devices behind
the IPSec routers at either end of a VPN tunnel.
Two active SAs cannot have the local and remote IP address(es) both the same. Two active
SAs can have the same local or remote IP address, but not both. You can configure multiple
SAs between the same local and remote IP addresses, as long as only one is active at any time.
72
DESCRIPTION
Type up to 32 characters to identify this VPN gateway policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
When the ZyWALL is in router mode, enter the WAN IP address or the domain name
of your ZyWALL or leave the field set to 0.0.0.0.
The ZyWALL uses its current WAN IP address (static or dynamic) in setting up the
VPN tunnel if you leave this field as 0.0.0.0.
The VPN tunnel has to be rebuilt if this IP address changes.
When the ZyWALL is in bridge mode, this field is read-only and displays the
ZyWALL's IP address.
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
Click Back to return to the previous screen.
Click Next to continue.
ZyWALL P1 User's Guide