Static Route; Chapter 17 Static Route; Ip Static Route; Figure 182 Example Of Static Routing Topology - ZyXEL Communications ZYWALL P1 User Manual

C
H A P T E R
This chapter shows you how to configure static routes for your ZyWALL.

17.1 IP Static Route

Each remote node specifies only the network to which the gateway is directly connected, and
the ZyWALL has no knowledge of the networks beyond. For instance, the ZyWALL knows
about network N2 in the following figure through remote node Router 1. However, the
ZyWALL is unable to route a packet to network N3 because it doesn't know that there is a
route through the same remote node Router 1 (via gateway Router 2). The static routes are for
you to tell the ZyWALL about the networks beyond the remote nodes.

Figure 182 Example of Static Routing Topology

17.2 IP Static Route
Click ADVANCED > STATIC ROUTE to open the IP Static Route screen (some of the
screen's blank rows are not shown).
The first static route entry is for the default WAN route. You cannot modify or delete a static
default route.
The default route is disabled after you change the static WAN IP address to a dynamic WAN
IP address.
ZyWALL P1 User's Guide
17

Static Route

287