Where "i" specifies binary image transfer mode (use this mode when transferring binary files),
"host" is the ZyWALL's IP address, "put" transfers the file source on the computer
(firmware.bin – name of the firmware on the computer) to the file destination on the remote
host (ras - name of the firmware on the ZyWALL).
Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.
23.22 Restart Screen
System restart allows you to reboot the ZyWALL without turning the power off.
Click MAINTENANCE > Restart. Click Restart to have the ZyWALL reboot. Restart is
different to reset; (see
configuration.
Figure 250 MAINTENANCE > Restart
ZyWALL P1 User's Guide
Section 23.18.3 on page
Chapter 23 Maintenance
383) reset returns the device to its default
389