Figure 235 Maintenance > Device Mode (Router Mode); Table 141 Maintenance > Device Mode (Router Mode) - ZyXEL Communications ZYWALL P1 User Manual

Chapter 23 Maintenance
You can use the firewall and VPN in bridge mode.The following applies when the ZyWALL
is in router mode.
Figure 235 MAINTENANCE > Device Mode (Router Mode)
The following table describes the labels in this screen.
Table 141 MAINTENANCE > Device Mode (Router Mode)
LABEL
Device Mode
Device Mode Setup
Router
IP Address
Bridge
IP Address
IP Subnet Mask
Gateway IP
Address
Zero Configuration
Mode
Apply
Reset
374
DESCRIPTION
This displays whether the ZyWALL is functioning as a router, bridge or simplified
router (zero configuration).
When the ZyWALL is in router mode, there is no need to select or clear this radio
button.
Click LAN or WAN to go to the screen where you can view and/or change the
corresponding settings.
Select this radio button and configure the following fields, then click Apply to set
the ZyWALL to bridge mode.
Enter the IP address of your ZyWALL in dotted decimal notation. Use an IP
address in the same subnet as the network to which you connect the ZyWALL.
Make sure the IP address does not conflict with any other device on the network.
Enter the IP subnet mask of the ZyWALL.
Enter the gateway IP address.
Use zero configuration mode to have the ZyWALL configure most settings
automatically. This is useful for travelers or telecommuters.
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Click Reset to begin configuring this screen afresh.
ZyWALL P1 User's Guide