Internet Access; Network Status; Figure 252 Internet Access (Network Status); Table 149 Internet Access (Network Status) - ZyXEL Communications ZYWALL P1 User Manual

Chapter 24 Zero Configuration Screens
• Use INTERNET ACCESS to see general network status information and configure the
Internet access settings (see
• Click SECURITY to enable or disable the ZyWALL's IDP and anti-virus features and
update the IDP signatures and anti-virus patterns file (see
• Click LOGS to display the ZyWALL's logs (see
• Click ADVANCED to go to the login screen for the regular web configurator screens.
• Click EXIT to close the screen.

24.2 INTERNET ACCESS

The INTERNET ACCESS screen displays when the ZyWALL is set to zero configuration
mode. This screen displays general network status information about the ZyWALL and allows
you to configure the Internet access settings.

24.2.1 Network Status

The first part of this screen displays general network status information about the ZyWALL.

Figure 252 INTERNET ACCESS (Network Status)

The following table describes the Network Status labels in this screen.

Table 149 INTERNET ACCESS (Network Status)

LABEL
Interface
Status
394
Section 24.2 on page 394
DESCRIPTION
This is the port type.
For the LAN port, this displays the port speed and duplex setting. Ethernet port
connections can be in half-duplex or full-duplex mode. Full-duplex refers to a
device's ability to send and receive simultaneously, while half-duplex indicates that
traffic can flow in only one direction at a time. The Ethernet port must use the same
speed or duplex mode setting as the peer Ethernet port in order to connect.
For the WAN port the port speed and duplex setting display if you're using Ethernet
encapsulation and Down (line is down or not connected), Idle (line (ppp) idle), Dial
(starting to trigger a call) or Drop (dropping a call) if you're using PPPoE
encapsulation.
for details).
Section 24.3 on page
Section 24.4 on page 401).
ZyWALL P1 User's Guide
400).