Configuring Netbeui; Configuring A Windows 95/98/Me Computer; Configuring A Windows 2000 Computer - Ricoh Priport DX 4640PD Network Manual

Windows Configuration

Configuring NetBEUI

This section describes how to configure Windows to use NetBEUI.
Limitation
❒ NetBEUI cannot be used under Windows XP or Windows Server 2003.
Note
❒ NetBEUI appears as SMB in the control panel, manual, and related utilities.

Configuring a Windows 95/98/Me Computer

Follow the procedure below to configure a Windows 95/98/Me computer to use
4
NetBEUI.
A
Open [Control Panel], and then double-click the Network icon. Make sure
[NetBEUI] is listed in the [The following network components are installed] box on
the [Configuration] tab.
Note
❒ If NetBEUI is not installed, click [Add...] on the [Configuration] tab to install
it. For details about installing NetBEUI, see Windows 95/98/Me Help.
❒ If [NetBEUI →Dial-Up Adaptor] is listed in the [The following network components
are installed] box, select it, and then click [Remove] to remove the binding.
B
Click [OK] to close the [Network] dialog box.

Configuring a Windows 2000 Computer

Follow the procedure below to configure a Windows 2000 computer to use Net-
BEUI.
A
On the [Start] menu, point to [Settings], and then click [Network and Dial-up Con-
nections].
B
Double-click [Local Area Connection]. On the [General] tab, click [Properties].
C
Make sure [NetBEUI Protocol] is selected in the [Components checked are used by
this connection] box on the [General] tab.
Note
❒ Select NetBEUI if it is not already selected.
❒ If NetBEUI is not installed, click [Install] on the [General] tab to install it. For
details about installing NetBEUI, see Windows 2000 Help.
D
Click [OK] to close the [Local Area Connection Properties] dialog box.
18