Table of Contents
Advertisement
moving the cursor to "Temporary" and pressing the ENT Key to check or
uncheck the box.
7) Press the FMS Knob to remove the flashing cursor.
Or:
1) Press the FMS Knob to activate the cursor.
2) Enter a user waypoint name (up to six characters).
3) Press the ENT Key. The message 'Are you sure you want to create the new
User Waypoint AAAAAA?' is displayed.
4) With 'Yes' highlighted, press the ENT Key.
5) If desired, define the type and location of the waypoint in one of the
following ways:
Select "RAD/RAD" using the small FMS Knob, press the ENT Key,
and enter the two reference waypoint identifiers and radials into the
'Reference Waypoints' Window using the FMS Knobs.
Or:
Select "RAD/DIS" using the small FMS Knob, press the ENT Key, and
enter the reference waypoint identifier, the radial, and the distance into
the 'Reference Waypoints' Window using the FMS Knobs.
Or:
Select "LAT/LON" using the small FMS Knob, press the ENT Key, and
enter the latitude and longitude into the 'Information' Window using
the FMS Knobs.
6) Press the ENT Key to accept the new waypoint.
7) If desired, change the storage method of the waypoint to "Temporary" or
"Normal" by moving the cursor to "Temporary" and pressing the ENT Key
to check or uncheck the box.
8) Press the FMS Knob to remove the flashing cursor.
Creating a user waypoint from the 'FPL - Active Flight Plan' Page:
1) Press the FPL Key.
2) Press the FMS Knob to activate the cursor (not required on the PFD).
3) Select the point in the flight plan before which to add the new user
waypoint. The new waypoint is placed directly in front of the highlighted
waypoint.
190-02040-01 Rev. B
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Flight Management
35
Advertisement
Table of Contents
