Table of Contents
Advertisement
Message
NAV #[1, 2] INOP - INTRL – Com
internal fault.
NAV #[1, 2] INOP - SERIAL –
Check NAV serial communication.
NAV1 MANIFEST – NAV1 software
mismatch, communication halted.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
NAV1 SERVICE – NAV1 needs
service. Return unit for repair.
NAV2 MANIFEST – NAV2 software
mismatch, communication halted.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
NAV2 SERVICE – NAV2 needs
service. Return unit for repair.
NAV #[1, 2] INOP - SYNTH
LOCK – COM synthesiser lock fault.
NO RUNWAY POSITION DATA
– Inhibit SurfaceWatch. No runway
position data.
NO WGS84 WPT – Non WGS 84
waypoint for navigation -[xxxx]
NON-MAG UNITS – Non-magnetic
NAV ANGLE display units are active.
PFD1 BACKLIGHT CAL – PFD1
calibration lost. Return for repair.
PFD POSITIONS DIFFERENT
– PFD positions mismatch. Check
position sensors.
PFD1 CARD 1 ERR – Card 1 is
invalid.
190-02040-01 Rev. B
Comments
NAV 1 and/or NAV 2 has an internal fault.
Loss of NAV 1 and/or NAV 2 serial communication. Check NAV
serial communication.
NAV1 software mismatch. The system should be serviced.
The remote NAV1 transfer switch is stuck in the enabled (or
"pressed") state. Press the transfer switch again to cycle
its operation. If the problem persists, the system should be
serviced.
A failure has been detected in the NAV1 receiver. The receiver
may still be available. The system should be serviced.
NAV2 software mismatch. The system should be serviced.
The remote NAV2 transfer switch is stuck in the enabled (or
"pressed") state. Press the transfer switch again to cycle
its operation. If the problem persists, the system should be
serviced.
A failure has been detected in the NAV2 receiver. The receiver
may still be available. The system should be serviced.
NNAV 1 and/or NAV 2 has a synthesizer lock fault.
Inhibit SurfaceWatch.
The position of the selected waypoint [xxxx] is not calculated
based on the WGS84 map reference datum and may be
positioned in error as displayed. Do not use GPS to navigate to
the selected non-WGS84 waypoint.
Navigation angle is not set to MAGNETIC at power-up.
The PFD backlight calibration cannot be found or is invalid. The
system should be serviced.
There is a mismatch in the position sensed by the PFDs. Check
position sensor settings. If message persists the system should
be serviced.
The SD card in the top card slot of the specified PFD contains
invalid data.
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Annunciations & Alerts
209
Advertisement
Table of Contents
