Table of Contents
Advertisement
6) If 'Manual' was selected, use the FMS Knobs to enter the field elevation of
the destination airport in the 'ELEV' field and press the ENT Key.
7) If 'FMS DEST' was selected, the field elevation of the selected destination
airport/runway from the flight plan will be shown in the BARO QFE Box.
Verify this information is correct.
8) The 'On/Off' Field will automatically highlight, turn the small FMS Knob to
change the selection from 'Off' to 'On'.
9) Push the FMS Knob to deactivate the cursor. BARO QFE mode is now
armed.
10) Enter the desired QFE BARO setting to activate the BARO QFE mode.
Change the BARO setting on both PFDs to STD BARO to disable BARO QFE.
The desired BARO setting can now be entered.
Setting the Baro Transition Alerts:
1) Use the FMS Knob to select the 'Aux - System Setup 1' Page on the MFD.
2) Push the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight Altitude or Level in the Baro Transition
Alert box.
4) Turn the small FMS Knob to turn the alerts 'OFF' or 'ON' and press the ENT
Key.
5) Turn the small FMS Knob to change the altitude or level and press the ENT
Key.
6) To cancel the selection, push the FMS Knob.
Enabling/disabling the HSI Map on the PFD:
1) Press the Map/HSI Softkey.
2) Press the Layout Softkey.
3) Press the HSI Map Softkey to enable the HSI Map.
Or:
Press the Map Off Softkey to disable the HSI Map.
Adjusting the Selected Heading:
Turn the HDG Knob to set the Selected Heading.
Press the HDG Knob to synchronize the bug to the current heading.
190-02040-01 Rev. B
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Flight Instruments
5
Advertisement
Table of Contents
