Table of Contents
Advertisement
Message
HOLD EXPIRED – Holding EFC time
expired.
HW MISMATCH – GIA hardware
mismatch. GIA1 communication
halted.
HW MISMATCH – GIA hardware
mismatch. GIA2 communication
halted.
INSIDE ARSPC – Inside airspace.
INVALID ADM – Invalid ADM: ATN
communication halted.
LOCKED FPL – Cannot navigate
locked flight plan.
LOI – GPS integrity lost. Crosscheck
with other NAVS.
LRG MAG VAR – Verify all course
angles.
MANIFEST – MFD1 software
mismatch. Communication halted.
MANIFEST – PFD1 software
mismatch. Communication halted.
MANIFEST – PFD2 software
mismatch. Communication halted.
MFD1 BACKLIGHT CAL INV –
MFD1 calibration lost. Return for
repair.
MFD1 CARD 1 ERR – Card 1 is
invalid.
MFD1 CARD 1 REM – Card 1 was
removed. Reinsert card.
MFD1 CARD 2 ERR – Card 2 is
invalid.
MFD1 CARD 2 REM – Card 2 was
removed. Reinsert card.
190-02040-01 Rev. B
Comments
Expect Further Clearance (EFC) time has expired for the User
Defined Hold.
A GIA mismatch has been detected, where only one is SBAS
capable. The system should be serviced.
The aircraft is inside the special use airspace.
Data link avionics were not configured correctly and therefore
will not be able to communicate with the ground network.
This occurs when the pilot attempts to activate a stored flight
plan that contains locked waypoint. Remove locked waypoint
from flight plan. Update flight plan with current waypoint.
GPS integrity is insufficient for the current phase of flight.
The GDU's internal model cannot determine the exact magnetic
variance for geographic locations near the magnetic poles.
Displayed magnetic course angles may differ from the actual
magnetic heading by more than 2°.
The MFD has incorrect software installed. The system should be
serviced.
The PFD has incorrect software installed. The system should be
serviced.
The MFD backlight calibration cannot be found or is invalid. The
system should be serviced.
The SD card in the top card slot of the specified MFD contains
invalid data.
The SD card was removed from the top card slot of the specified
MFD. The SD card needs to be reinserted.
The SD card in the bottom card slot of the specified MFD
contains invalid data.
The SD card was removed from the bottom card slot of the
specified MFD. The SD card needs to be reinserted.
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Annunciations & Alerts
207
Advertisement
Table of Contents
