Table of Contents
Advertisement
18) To view database information for an individual display:
a) Turn the large FMS Knob and select Aux.
b) Turn the small FMS Knob and select System Status.
c) Press the Display Database Selection Softkey (MFD1 DB, PFD1 DB, PFD2
DB) to show database information for each display. Use the small FMS
Knob to scroll through the database information. Press the ENT Key or
the FMS Knob to exit.
Updating Databases Using Bluetooth Transceiver
In order to load databases through Garmin Pilot and the Bluetooth Transceiver, the
Bluetooth Transceiver must be enabled on the system and inserted in the bottom SD slot
of the MFD. A mobile device with Garmin Pilot must be paired with the Bluetooth Trans-
ceiver over Bluetooth (Refer to the Additional Features section). When there is at least one
paired device available to connect, the Bluetooth Transceiver will automatically connect to
the system' s preferred mobile device. The preferred device can be selected on the Aux –
Databases page from a menu list of paired devices.
Once a connection to the paired mobile device is made, Garmin Pilot makes available
databases that can be transferred to the Bluetooth Transceiver. If any of these databases is
more recent than the respective standby database on the system, (or if there is no standby
database on the system) those databases will be automatically selected to load. The da-
tabase updates may be initiated from the 'Aux - Databases' Page, or from other pages on
the MFD.
NOTE: The system will only provide a WiFi connection if new databases have
been detected for download on Garmin Pilot via a valid Bluetooth connection.
If there are no database updates required the system will not provide a WiFi
signal.
NOTE: If the mobile device has previously connected to the Bluetooth Trans-
ceiver, and is not connected to another bluetooth source, the mobile device
should connect automatically to the Bluetooth Transceiver. If the mobile device
is connected to another bluetooth source, then the Bluetooth Transceiver will
not connect automatically.
Updating Databases from any MFD page (except the 'Aux - Data-
bases' Page):
1) Insert the Bluetooth Transceiver SD Card in the bottom slot of the MFD if
not already inserted.
190-02040-01 Rev. B
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Appendix
227
Advertisement
Table of Contents
