Table of Contents
Advertisement
Appendix
2) Turn the system ON.
3) Press the ENT Key or the right-most softkey on MFD display to
acknowledge the startup screen.
4) On the mobile device, start Garmin Pilot and touch Home > Connext >
Database Concierge.
5) Turn the large FMS Knob and select Aux.
6) Turn the small FMS Knob and select the Connext Setup.
7) Ensure that Wifi Database Import is enabled in the 'Device' Window (Refer
to Additional Features section for instructions to enable Wifi Database
Import).
8) Verify that the mobile device is enabled via Bluetooth in the Bluetooth
settings on the mobile device.
9) In the 'Paired Devices' Window on the 'Connext Setup' Page, ensure the
system is paired with the mobile device in use. (Refer to Additional Features
for instructions on connection to a preferred device).
NOTE: The database updates may now be continued from any MFD page,
however, the update windows shown in these instructions will not be shown
on the 'Aux - Databases' Page. Use the instructions for updating databases
from the 'Aux - Databases' Page if desired.
10) Press the Update Softkey when the following window appears. (Pressing
the View Softkey will allow database updates to be viewed from the 'Aux
Databases' Page, however, the windows shown below will not appear on
the 'Aux Databases' Page. Pressing the Ignore Softkey will postpone the
updates until further action is taken.)
11) If using a device that has not been previously paired with the system, a
password prompt will appear on the mobile device. Enter the password
shown in the 'Password' Field of the 'Aux - Connext Setup' Page.
12) The database transfer window will appear. Database update progress may
be monitored on the mobile device.
13) When the transfer is complete, a screen will appear.
14) Press the Close Softkey.
NOTE: The Restart Softkey is enabled only when the aircraft is on the ground.
228
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-02040-01 Rev. B
Advertisement
Table of Contents
