Garmin Beechcraft 200 Series Cockpit Reference Manual page 249

Updating Databases Using a Supplemental Data Card
All databases are updated through a single SD card in the bottom slot of the MFD.
When the card is inserted, the databases on the card will be copied to standby and syn-
chronized across all powered, configured units. After update, the card is removed and
the databases are stored on the system. When in standby, databases are not immediately
available for use, but stored to be activated at a later time.
Database updates can be obtained by following the instructions detailed in the 'Aviation
Databases' section of the Garmin website (flygarmin.com). Once the updated files have
been downloaded from the website, a PC equipped with an appropriate SD card reader is
used to unpack and program the new databases onto an existing Supplemental Data Card.
Updating Databases:
1) With the system OFF, remove an SD Card from the bottom SD card slot of the MFD.
2) Download and install the databases on an SD card.
3) Put the SD Card in the bottom SD card slot of the MFD.
4) Turn the system ON.
5) Press the ENT Key or the right-most softkey on MFD display to
acknowledge the startup screen.
6) Turn the large FMS Knob and select Aux.
7) Turn the small FMS Knob and select Databases.
8) Monitor the Sync Status on the Databases page. Wait for all databases to
complete syncing, indicated by 'Sync Complete' being displayed. A cyan
double-arrow will appear between the Standby and 'Active' columns to
show which Standby databases will be transferred to Active at the next
power cycle.
9) Verify the correct database cycle information is shown in the 'Standby'
column.
10) Remove the SD card from the bottom slot of the MFD if desired.
NOTE: The Restart Softkey is enabled only when the aircraft is on the ground.
11) Press the Restart Softkey to restart the system and load the updated
database(s), or remove power from the system if the Restart Softkey is
diminished. A 10 second restart countdown will appear. Press the Restart
Button in the display window to continue with the restart of the system.
190-02040-01 Rev. B Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Appendix
225